Heat‐Transfer Modeling of Rapid, Large‐Area UV‐Assisted Sintering of TiO2 Films for Perovskite Solar Modules
Аннотация
ABSTRACT Titanium dioxide (TiO 2 ) is extensively utilized as an electron transport layer (ETL) in photovoltaic devices because of its high electron mobility and electron selectivity. However, high‐performance TiO 2 ETLs typically require high‐temperature sintering to obtain high crystallinity and interparticle connectivity, limiting their compatibility with flexible substrates. Several low‐temperature sintering methods suffer from insufficient film uniformity, limited scalability, and restricted substrate compatibility. Ultraviolet (UV)‐assisted sintering has emerged as a promising alternative but the fundamental heat‐transfer mechanism and the quantitative correlations between UV‐irradiation parameters (lamp‐to‐sample distance, peak wavelength, and power) and the resulting temperature distributions remain insufficiently understood. Here, a coupled radiative‐conductive heat‐transfer model is developed and experimentally validated to clarify transient top‐down heating and the vertical temperature gradients during UV sintering. Systematic parameter mapping identifies optimal operating condition that maximize the film‐substrate temperature difference () while maintaining the flexible substrate temperature below its glass‐transition temperature. Under the optimized condition, the model predicts = 40.21 K with saturation within 20 s, and experiments confirm dense, highly crystalline TiO 2 ETLs on flexible substrates without thermal deformation. Consequently, perovskite solar modules incorporating UV‐sintered TiO 2 ETLs achieve power conversion efficiencies of 20.58% on glass and 16.19% on flexible substrates (aperture area: 31 cm 2 ). image