Advanced Materials Interfaces Машиностроение

Hybrid Roll‐To‐Plate Printed CMOS Logic Circuits Via an Integrated Gravure‐Flexographic Printing Strategy

Junfeng Sun, Hyejin Park, Jinhwa Park, Zhouping Yin, Younsu Jung
Wiley · 2026-11-11 · DOI 10.1002/admi.70736

Аннотация

ABSTRACT Printed electronics offer a scalable route to large‐area, low‐cost, and flexible electronic systems, but multilayer integration remains limited by differences in ink rheology, film formation, and patterning requirements across functional layers. Here, we present a hybrid gravure–flexographic Roll‐to‐Plate (R2P) printing strategy for fully printed single‐walled carbon nanotube (SWCNT) thin‐film transistors (TFTs) and complementary metal‐oxide‐semiconductor (CMOS) logic circuits. Instead of using a single printing method across the device stack, we assigned flexographic printing to the gate and drain‐source (D‐S) electrodes, while using gravure printing for the dielectric, SWCNT semiconductor, and doping layers. The ∼45 nm‐thick flexographic‐printed gate enabled a uniform gravure‐printed BaTiO 3 dielectric with a thickness of 1.8 ± 0.08 µm and an areal capacitance of 13.2 ± 1.2 nF cm − 2 . The resulting p‐ and n‐type SWCNT‐TFTs exhibited mobilities of 0.08 and 0.05 cm 2 V − 1 s − 1 , respectively. Flexographic D‐S printing also reduced threshold‐voltage variation, improving device uniformity for circuit integration. Using these complementary transistors, we fabricated a fully printed CMOS ring oscillator operating at 60 Hz and a D‐Latch at 5 Hz, demonstrating the potential of layer‐specific hybrid printing for scalable printed CMOS electronics.

Читать у издателя →