ABSTRACT Sb 2 S 3 is regarded as a promising anode for sodium‐ion batteries (SIBs) because of its high theoretical capacity and moderate working potential. However, it suffers from huge volume changes, poor conductivity, and excessive side reactions, leading to severe capacity decay and a low initial Coulombic efficiency (ICE), thus limiting its practical use in SIBs. Herein, an Sb 2 S 3 /CS composite was synthesized solvothermally by anchoring Sb 2 S 3 nanorods onto lignite‐derived porous C and in situ doping the C with S. Specifically, lignite‐derived porous C simultaneously realizes the anchoring of Sb 2 S 3 nanorods and in situ S doping, constructing a strong C–S interfacial coupling structure that effectively buffers volume expansion and increases defect sites. This strategy optimizes surface chemistry to suppress polysulfide shuttling and induce a thin, uniform solid electrolyte interphase (SEI) film, thereby minimizing irreversible Na + consumption. Moreover, the hierarchical pores shorten ion transport pathways and enhance conductivity and active sites, thereby facilitating charge transfer kinetics. Consequently, the obtained Sb 2 S 3 /CS achieves an ICE of 88.9% at 0.1 A g −1 , retains 86.1% of its capacity when the current density is increased by 50‐fold, and maintains a capacity of 443.8 mAh g −1 after 2000 cycles at 5.0 A g −1 without significant capacity degradation.
Jia‐Hao Zhao, Zhi‐Huai Liu, Yu Gao, Bo‐Yu Sun, Xi‐Min Xu, Liu‐Ting Zhang, & Jin‐Long Cui (2026). Sb2S3 Nanorods Anchored on Lignite‐Derived Carbon With Strong C‐S Interfacial Coupling Enabling High Initial Coulombic Efficiency Sodium‐Ion Batteries. Rare Metals. https://doi.org/10.1002/rar2.70715
Jia‐Hao Zhao, et al. “Sb2S3 Nanorods Anchored on Lignite‐Derived Carbon With Strong C‐S Interfacial Coupling Enabling High Initial Coulombic Efficiency Sodium‐Ion Batteries.” Rare Metals, 2026. doi:10.1002/rar2.70715.
@article{Zhao2026,
title = {Sb2S3 Nanorods Anchored on Lignite‐Derived Carbon With Strong C‐S Interfacial Coupling Enabling High Initial Coulombic Efficiency Sodium‐Ion Batteries},
author = {Zhao, Jia‐Hao and Liu, Zhi‐Huai and Gao, Yu and Sun, Bo‐Yu and Xu, Xi‐Min and Zhang, Liu‐Ting and Cui, Jin‐Long},
journal = {Rare Metals},
year = {2026},
doi = {10.1002/rar2.70715},
url = {https://onlinelibrary.wiley.com/doi/10.1002/rar2.70715?af=R}
}
ABSTRACT Titanium dioxide (TiO 2 ) is extensively utilized as an electron transport layer (ETL) in photovoltaic devices because of its high electron mobility and electron selectivity. However, high‐performance TiO 2 ETLs typically...
ABSTRACT The properties of a material are governed by its building units of atoms. When the structural dimensions of a material approach the scale of the single atom, its intrinsic characteristics often exhibit emergent and distinct...
ABSTRACT Developing low‐cost and reactive iron sources is important for the sustainable production of LiFePO 4 (LFP) cathodes, yet the direct use of hematite concentrate (HC) is limited by impurity accumulation and insufficient...
ABSTRACT The clinical success of titanium (Ti) implants relies on establishing a favorable microenvironment to promote osseointegration. However, immune imbalance and metabolic dysregulation at the implant interface often trigger...
ABSTRACT The introduction of intermetallic phases into high‐entropy alloys (HEAs) frequently leads to embrittlement, primarily due to their inherent brittleness. Leveraging the remarkable hardness of these intermetallic phases while...